[Tdubbz]

I have tried to get it to work with the BACnet Time Synch. Cant seem to get a sync to work right with MSTP or IP controllers. You can set the time in the browser of the IP controllers but they will just reset back. MSTP controllers will set Time from CXpro but the time will need reset as soon as it power cycles. Best to disable the feature as it doesn’t work right.

[Tdubbz]

I would like to add to this post.
I am currently deploying Fusion Air Thermostats at a job and I have a few complaints about installation.

1) The latches that set the display onto the wall plate are extremely difficult to latch onto. You have to almost force it into place to the point you feel like you’re about to break it.

2) Dry wall dust/Airborne particulates can make it’s way into the display and obstruct the thermostat display. During installation if there is any dry wall dust near the stat there is a possibility of it getting stuck in the display. I can see this being an issue in the longterm as the display will collect dust over time and eventually cause complaints as you can’t clean it.

[Author]

Posts